(For Voltage Range 100～277 V)
Electrical:
Operate Voltage :100-277V ,50/60HZ
WARNING
Before proceeding with installation or service maintenance of this product:
• This product can only be connected to a single-phase AC power line with voltage level between Neutral and Hot terminals less than 277 volts. Any higher voltage level or multiple-phase power line connection (such as connecting to hot terminals on multiple-phase power line) could damage the product, and the warranty of the product would automatically be voided.
• Black Wire: Hot Terminal; White Wire: Neutral Terminal; Yellow-Green Wire: Grounding Terminal.
• Disconnect power to reduce electrical shock risk.
• Review the entire installation guide.
• Inspect properly packaged product for any damage that may have occurred during transit.

Step 1: Open packing box and take out luminaire and twist-lock photocell units. Install the twist-lock onto the receptacle base located on the top of the luminaire unit. Lock the photocell into position by turning the photocell in a clockwise direction.

Step 2: Unlock the latch locking mechanism (2) and open the luminaire door (3)

Step 3: Insert mounting arm into the luminaire mounting hole, as shown in the picture below. Note that the mounting angle can be adjusted by positioning mounting arm tip on the different step levels [see (5) in the picture below]. Tighten the 4 M10 screws (6) to securely mount the unit on the arm.

Step 4: Pull the power wires through the wire clip (7) and tighten the screws on the clip (7) to securely fasten the power wires. Connect the power wires to the terminal block to complete the wiring process. Note: Pay attention to terminal block positions with Marks L, N, and E. L is for Hot; N for Neutral; and E for Earth/Ground.

Step 5： Close the door and fasten the latch to lock the door into position to complete the installation.